Balanced gates that meet where they should
Leaf sizes planned
Equal and unequal layouts are considered around vehicles and pedestrian use.
Accurate centre alignment
We set both leaves to meet cleanly instead of fighting each other.
One continuous design
Arches and decoration can flow across the pair when the gates are closed.
Split a wide opening into useful leaves
Double driveway gates divide a broad entrance into two manageable sections and create a balanced frontage when they are closed. We measure vehicle width, ground levels and available swing room before setting the leaf sizes. Equal leaves give a symmetrical appearance. Unequal leaves can provide a more useful pedestrian section for everyday access without opening the full entrance. We also check how vehicles approach and leave the drive, as clearance on paper means little if the gate sits directly in the turning line.
Get the centre line and hardware right
Two leaves only work well when their meeting stiles line up cleanly. We plan the hinge positions, centre alignment, drop bolts and ground stops as one system, then check each part during fitting. An arched top can run continuously across both leaves, with scrolls or repeated details laid out around the centre. If you are considering automation, we assess post stability, gate movement and the space behind the entrance. Those site conditions help determine whether the chosen layout is practical.
Frequently asked questions
Do both leaves need to be the same width?
No. Equal leaves create symmetry, while unequal leaves can provide a smaller section for pedestrian access. We measure the entrance and discuss normal vehicle movement before deciding which arrangement will be easiest to use.
Can double gates have an arched top?
Yes. We can design the arch so it continues across both leaves and meets at the centre. Decorative elements can also be mirrored or repeated. Accurate measurements help keep the overall shape balanced when the gates are closed.
Can existing double gates be replaced with automated ones?
We first need to assess the opening, posts, ground clearance, leaf movement and available space. Automation also needs suitable controls, power, manual release and safety equipment. We discuss the complete system before preparing the estimate.